Description
The Yokogawa YCB147-2 is a control bus cable conversion adapter from Yokogawa’s CENTUM CS 1000/CS 3000 and CENTUM VP accessory line. It is a passive, rack-mountable hardware component that performs physical-layer interface conversion and termination matching between different Vnet coaxial cable types. The Yokogawa YCB147-2 carries the “-2” suffix denoting a two-connector, non-explosion-proof standard configuration, while the commonly referenced /BR option designates the 19-inch rack-mount form factor .
Application Scenarios
In a legacy CENTUM CS 3000 installation, the Vnet control bus often spans multiple cabinet sections using different coaxial cable gauges. A trunk run between process units may employ 10BASE-5 thick coaxial cable for its 500-meter reach, while intra-cabinet jumpers and short inter-rack connections use thinner, more flexible 10BASE-2 cable limited to 185 meters. These two cable types use incompatible connector interfaces—N-type for thick coax, BNC for thin coax—and cannot be mated directly without introducing impedance discontinuities and signal reflection. The Yokogawa YCB147-2 resolves this physical-layer mismatch by providing a properly terminated transition point. In a refinery DCS modernization where an existing CS 3000 system was being extended with new VP cabinets, engineers used the Yokogawa YCB147-2 at each cabinet boundary to bridge the legacy thick-coax backbone to the new thin-coax distribution segments. Without the adapter, the project would have required re-cabling the entire Vnet backbone or installing active repeaters, both of which carried significant cost and downtime implications .
Parameter
| Main Parameters | Value / Description |
|---|---|
| Product Model | Yokogawa YCB147-2 (with /BR rack-mount option) |
| Manufacturer | Yokogawa Electric Corporation, Japan |
| Product Category | Control Bus Cable Conversion Adapter (Passive) |
| Compatible Systems | CENTUM CS 1000 / CS 3000 / CENTUM VP |
| Supported Bus | Vnet (10BASE-2 and 10BASE-5 coaxial) |
| Connector Quantity | 2 (−2 suffix denotes two connectors) |
| Exposed Rating | None (no F suffix; not ATEX/FM/CSA rated) |
| Operating Mode | Passive, no external power required |
| Impedance Matching | 50 Ω coaxial with built-in termination resistor |
| Electrical Isolation | 500 V AC (per some channel documentation) |
| Operating Temperature | 0°C to +55°C (basic type) |
| Mounting | Panel mount or 19-inch rack (with /BR option) |
| Protection Rating | IP20 (cabinet interior) |
| Weight (bare unit) | Approximately 100 g |
| Lifecycle Status | End-of-Life (EOL); limited stock availability |
WhatsApp:+86 18005022363 WeChat: +86 18005022363
Email:






